The good, the bad, the ugly - this is ugly.

The good, the bad, the ugly - this is ugly.

The Original Plan.

I was to run a PSS 265-40-20 and 285-35-20 to keep the Genuine OEM sidewall ratio.

It would raise the car by 1.31 inches at the front and about 1 inch at the rear. I would lower it afterwards with the Bilstein B16 Damptronics that should have been here by now. 

But the Canadian Border Agency had other plans for the PapiExpress. 

The Temporary Fit.

I was able to fit the 285-35-20 on the 10.5 rear wheels with BBS' 5mm spacer. It's just as I intended. 

Meaty, fitted and no rubbing. 

...but the front was a different story. 

The 265-40 would hit the perch even with the 10mm spacer. 

I had to make due with a Continental ExtremeContact 265-30-20 that I had laying around.

That's a ridiculous 2 inches lower than planned. 

From bad to worse. 

I knew from experience the height difference was going to cause problems. 

The MSS65 thinks the front wheels are going way faster than the front.

It wrecks havoc on its computations.

The car won't drive with Traction Control on, the SMG doesn't understand what's going on. 

TC off & S6 it is then :) 



This is all temporary - but as with anything I do, I share the good, the bad and the ugly.

This is ugly.

Cheers,
Matt


Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.